leaking T.E.S.

[ReaLe[e]LAZY]

I juz got my T.E.S. today but iv been having a bit of a problem. It is leaking through what seems to be the gauge. i havent tried ne thing just wanted to know if ne one else had the problem and how 2 fix it.

[Omegaboy13]

Teflon that bad boy.

[NC demolition]

teflon tape the gauge threads, around the orings on the front block, and the screw that secures the front block.. doubt you have any leaking after that

[ReaLe[e]LAZY]

ok nvm, it is leaking out the front block. i took it off but didnt no wat to do. All the o-rings looked fine, but it is ok to teflon the o-rings? wel i try that see wat happens.

[ReaLe[e]LAZY]

ok tefloning the front block didnt work, or did i not put enough. I didnt want 2 put 2 much becuz then it just starts sliding back. What else should i try?

[macfights]

the stock o rings suck... change them... and yes you can use tank orings

[NC demolition]

you also can teflon the screw that holds on the front block

[ReaLe[e]LAZY]

ok, i tefloned it again and it stopped. i think it is leaking again though i dont have a full Co2 tank it empty. Also i heard about the eye not sensing dark paint... is orange dark? i was firing orange through it and i had 2 turn the eye off cause it wasnt working. Then i put a yellow/green paint and it was sensing that. Doesnt make sense, it was a light orange, lighter than the green, it must be sensing the yello i guess...