Newb Tes Question

[ProSccrPlayer]

I am new to paintball and have bought a TES what operating pressure does it run at? Thanks

[Ivar Nelson]

The TES can operate at anywhere from 300-475 psi as it comes stock. Mine is at 400. The deciding factor is velocity. If you can not get 285 with 450 psi, lube your bolt and striker assembly first, and recheck. If you are still slow you need a stronger striker spring. (Or just stretch it 1/4") The psi can be increased by turning the allen head bolt on the left side of the regulator. 500 is TOO MUCH. Lower than 350 may cause some leakage around the front block if the 0-rings are not broken in.
Hope this helps.
Ivar:blah:

[ProSccrPlayer]

Thanks, this helps me out a lot