A-5 owners please help If you upgraded to E-grip and palmer stab you may know

[DUKESTER]

This is what is going on. My setup was A-5 with responce triger. I just put a palmer stabalizer on and E-grip. Went outside to try it out and The cylone is not spinning half the time when I shoot. It seems to not spin at all when I go fully auto. Has anyone got any Ideas what is up????

[spor]

i think u set eht pressure to low, not enough force to spin it. just my thoughts though

[yakitori]

yep, turn the pressure up.

[DUKESTER]

Thats what I was thinking, I have been adjusting the stab over to give more preasure you turn the allan screw in the direction of the + right. I forgot to mention I also have a rear valocity adjuster now and I screwed it all the way in the direction of the plus also.

[DUKESTER]

I was thinking may be I was loosing preasure from the old response trigger valve, But I think I shut it off by tightning down on the rt screw.

[DUKESTER]

I FIGURED IT OUT ON MY OWN. THANKS ANYWAY

[Turambar]

Originally posted by DUKESTER
I FIGURED IT OUT ON MY OWN. THANKS ANYWAY

Care to tell us what it was so if someone else has this problem they can fix it?

[DUKESTER]

Ok here it is. When you buy an e-grip for the a-5 to replace a responce triger. The problem I ran into is the grip wont fit on the a-5 because of the rt. triger rate of fire screw valve over the grip area. I was told to drill a 1/2 inch hole in the grip so the valve would slide in and the grip would go on.. This is incorect. What happens when you do this is the rt valve causes the air to backfeed into the new grip loosing air presure on every shot , thus causing the cyclone to loose preasure enough to turn it right. The solution is to call tippman. They make a special valve that takes the place of the T valve near the cyclone with a 90 valve to eliminate the rate of fire adjuster all together. This eleminates the RTs rate of fire adjuster letting the E grip go on properly without doing any modifying. Tippman is sending me the new valve for free. They are great. Hope this will help anyone trying to put the E-grip on where a RT trigger was.

[Big Miles]

Get a regular A-5 with out the response trigger. Then just buy the elec trigger for your regular A-5. Less money more marker! We call it the bonus plan!

Flatline, with the chronic! Try it you'll like it!

[Kdizzle]

yo do you think a 32degrees ice cld barrel will work on an A-5

[-=ReD-hAzE=-]

If it has the proper barrel threading it will work. :o