burst
03-07-2004, 03:51 AM
OK, I have a B2K3 with PDS. I bought the Chaos 2K4 board but when I seated the board to the harness and turned on the marker I noticed the LED was not working. I rechecked the connection but it was good. I figured I must have pulled a wire or something so to check I replaced my stock board. The LED was working again. I reinstalled the Chaos and had the same problems all over again. Anyhow, I thought it may have something to do with the wiring harness so I ordered Vapors wiring harness. Got it, placed it on the marker......guess what, I'm having the same problems.
Has anyone come across this same problem? Have any idea what could be causing it?
I bought the Entropy cable and software figuring I could get around the LED problem but I'm not having any luck getting it to read the Chaos chip on either of my computers. The Chaos board does fire when turned on so it’s not a dead board.
Any help given will be greatly appreciated.
Has anyone come across this same problem? Have any idea what could be causing it?
I bought the Entropy cable and software figuring I could get around the LED problem but I'm not having any luck getting it to read the Chaos chip on either of my computers. The Chaos board does fire when turned on so it’s not a dead board.
Any help given will be greatly appreciated.