Please HELP!

[Joeykid]

I am not sure if this is normal but anyway here goes, My blazer works fine when the tank is full, but when the tank is almost not full, it just starts leaking out the barrel. Could this be my reg, I have a Gladiator? It did it when I 1st put on the Gladiator but I turned up the pressure and it was fine, I dont know if I have to adjust it every time the tank pressure gets too low. Please respond if u know anything.

[Creek]

you are using air or co2,also what do you have the reg set at

[Joeykid]

I use compressed air, I am not sure what the reg is set at cuz theres no guage, but if I had to guess it would be around 500psi.

[Joeykid]

So what do u think?

[Creek]

have you a just the rock reg on the side of the maker yet. if not back it out pulling the trigger till it wont cock. then start turning it in till it cocks pulling the trigger each time. once it cocks turn it a quarter of a turn and then it be set.