Converting to LP

[legion]

I'm thinking of converting my marker to run at low pressure on CO2. From what I gather, I will need to get the following:

-Turbo Valve
-Secondary Regulator

I also think that getting the Ram Air chamber will help too.

Does anyone know of a secondary regulator that I can swap for the gas-thru foregrip that has a built-in pressure gauge? (From what I can tell, the Pure Energy replacement has no gauge.)

[Dermen]

Do you still have the box from the STS. If you do some of them say that the STS comes with a turbo valve. If yours does you can cut it out and send it to PMI and they will give you a turbo valve. If not then yes you should buy one. Getting a low pressure chamber would help. You should also get an anti-syphon tube put in your tank. If you want the PE reg then you should get it. You can always have a guage put into your vertical ASA. You can do it yourself or have somebody do it for you. It shouldnt cost too much to have done. If you want a reg with a guage I have heard good things about the CMI R-2000 reg when used as a secondary or as a primary. Wow I wrote too much.

[legion]

Thanks for the info--I never got the exterior box for my marker. I ordered from xpaintball.com and they shipped it wrapped in bubble paper in a big box.

Do you have to have a threaded hole created in the ASA to put a guage there?

[Dermen]

Check out this site. It tells alot about making your STS LP and how to install a guage.

http://home.hiwaay.net/~jmorris/