Blade Trigger

[Supra333]

This is really *** I got a local store to install a magno blade trigger on my gun and the other day the board didnt pick up a signal or anything and I took it in and they fixed it.....but now it is doing it again......anyone know wat i can do?

[chunkers05]

Go back and ask them to fix it for good, they installed it, they should do it right, and if it's not right, fix it for free.

[Spyderer]

possible teh set screws are backing out slowly, do you have them loctited? if not then loctite the set screws so they dont screw out. or superglue if you dont have loctite

[Hyperballin]

TAKE IT BACK they should locktite it for you

[jester33]

same thing happened to me my led light wouldnt come on how to fix it is too your trigger is too close

[Imagine stinks]

if you have a 2k4 imp look at the bottom and the trigger guard should have a hole near the grips, put an allen wrench down in the and probubally turn out until your light come back on.

[toothpastedog]

well, if the trigger moves it is the micro switch activation screw, which needs to be readjusted. if the trigger doesn't move at all do what imagine stinks said. to adjust the micro switch activation screw (it is the one that goes straight up into the trigger, and it is between the pre and post travel screws. what you should do is, turn the impulse on, then while watching the light on the back, unscrew the screw slowly, and when the light starts flashing again pull the trigger a couple times. if it work great, if not watch the light on the back and unscrew the micro switch activation screw some more until it starts to blink again. good luck.