Hopper wobble??

[dye_12345]

Yea i know what your all thinking of doing, your goign to yell at me, but my elbo wiggels and alot of people say the o-ring trick, but i lost one of the pins and i cut a metel hanger and put it in there and i cant get it out. So is there anything eles i can do? (rember i cant take the elbow off) and nothing g@y like cloth in between the frot site (were it clicks you know what i mean)

[Coenen]

I know how, but I think you'll be able to figure it out on your own, or by doing a search.

Think of what the O-ring mod does to it and how you might get that same effect without an O-ring. You'll feel a better sense of accomplishment from using your own brain instead of ours.

[dye_12345]

I did search, and all i found was the o-ring mod and some tape one and most people say that that one is sticky :rolleyes:

[Coenen]

Try a strip of rubber band and glue. A wide band fits perfectly just below the feed port.

Now was that really so hard?

[hambone]

snap!!!! :bullwhip:

and dont be an idiot and use elmers glue or something like that...spend the .98 cents and get some superglue.

or you can do what i did and just paint your marker, decide you dont like it repaint it, decide you dont want the color, repaint it, get bored with the color and repaint it again. now my feedneck fits snuggly against my marker with no wobble or vibration due to the layers of paint and primer on the marker.

[Turambar]

Get four peices of cloth tape and put them in the curve on the elbow.


Originally posted by hambone
or you can do what i did and just paint your marker, decide you dont like it repaint it, decide you dont want the color, repaint it, get bored with the color and repaint it again. now my feedneck fits snuggly against my marker with no wobble or vibration due to the layers of paint and primer on the marker.

Don't do that. After a while the paint will just stop sticking to your gun because there is so much crap on it.