vertical adapter installation

[mello]

Was the last turn into the valve near impossible for u guys ? I can't get it all the way around again so that only one tread shows on the adapter.

[liquidsoul_sm]

If you don't have the muscle you will have to use the a wrench. Make sure you are using the wrench at the elbow not at the tank adapter. Also put a piece of cloth around the elbow that way the adapter does not scratch.

[CountyPaintball]

Most importantly, do NOT use the power tube for leverage. You'll likely break it.

Mike

[Toolfreak387]

i didnt get it down to one thred and mine works fine. just get it as far as you can...and use alot of loctite.

[liquidsoul_sm]

On mine, there is about 3 threads remaining and it is fine. I put alot of locktite on it though. Between the 3 threads that you need to put locktite on you should use all of the little bottle that comes with it. That is all that you need.