MacGyver
11-07-2001, 06:47 PM
ok so i installed my blade trigger, my eclipse VRM and my kapp DR II with on/off. when i finished i checked all my fittings to make sure they were leak proof and turined on the gas. the marker charged to 150psi and i pulled the trigger. nothing. stupid me forgot to turn it on (i'm new to electros). so i turned it on and pulled the trigger and boom the hose splits open. could the hose have blown because the marker was gassed up before it was turned on? i hooked up the hose to the hole marked inlet on the reg.
the only other thing that i could think of its that when did the trigger i took the grip frame off and the wire for the selinoid came off before i could see which wire went to which pin. if i put it on backwards would the have some kind of reverse pressure on the hose? thanks in advance for reading this long post and thanks for any advise that you may post. add ons to the thread, emails and PMs all welcome
the only other thing that i could think of its that when did the trigger i took the grip frame off and the wire for the selinoid came off before i could see which wire went to which pin. if i put it on backwards would the have some kind of reverse pressure on the hose? thanks in advance for reading this long post and thanks for any advise that you may post. add ons to the thread, emails and PMs all welcome