Jt Slam Pak Collar

[TeamFury]

I just bought a JT Slam Pak and I can't get it onto the hopper. I am trying to put it onto a regular hopper because I haven't bought my revvy yet. Help me Please. If anyone knows of a website that will show me how to please tell me!

[Killer Kat]

I've got two, And they work great (once you get'em on!)I've long since thrown away my instructions, so I'm going strictly from memory. First things you'll need is a 5/32 drill bit and drill, phelps screw driver (smaller size)and a clean flat work surface.
When you hold the collar in your hand facing you is a large brass screw that goes across the front, remove that screw there will be a plastic shim that will either be used to fit on to your hopper or can be tossed, loosen the remaining screws (so that it will be able to slip over the opening of the hopper) in the collar, set the collar aside for now.
Next remove the screw under the opening in the hopper (it's the one on the opposite side of the low battery led) Here's where the drill comes into play, drill that entire screw hole out, both sides should be drilled. The big brass screw should be able to now fit thru that hole (check it out, make sure it fits)
If the screws are loose enuff in the collar, the collar should slip over the opening of the hopper. See if the shim is needed. Put the brass screww thru and tighten all the other screws up as well. Now go tell your friends to be afraid! Be very very Afraid!:D

[TheSickness]

can you put the collar on ric2ks or is it only for vls

[TeamFury]

Those are the instructions to put it on revvys right?

[Killer Kat]

Yes those are Revy instructions, I've never tried to get them on anything else.