x-chamber question..and others

[felony]

ive heard that you can remove the "baffles" or "stages" in a x-chamber to make it a gas through.

i want to do this because i have HPA so i dont need the expand part.

does this work?
should i even do it?

any have the fullboar shadow??
im kinda stuck between that and the lowpressure kit..

anyone got suggestion??

thanks
dan

[liquidsoul_sm]

It is possible to remove the stages from an expansion chamber. However, expansion chambers usually are in two halves that swivle. If you were to remove the stages you would find that the air would leak out of the swivle part of the grip. There really is no need to remove it. It actually won't harm anything. What kind of expansion chamber do you have? What questions do you have about the full boar? The full boar has nothing to do with low pressure. What exactly do you mean you are stuck between the two?

[felony]

i have a ACI 6stage subzer x-chamber

i have just heard that it ruins your consistency to run nitro through a x-chamber


i was stuck between the full boar and low pressure because i dont know which to get
i wnat rear cocking because i dont want to get crap-o in my gun, but i dont know what i want..
i dont know if i need/wnat lowpressure. i know what it does, i am just indecisive.

i really dont wanna spend 200+$ on the low pressure so i was kinda thinking of the shadow full boar, and maybe a vigilante for my nitro, and my 6 stage for if i need to run my co2 again..

im not sure

opinions?

thanks
dan

[in trauma]

i would sell the x-chamber and get a gas thru grip you will save money that way instead of destroying your x-chamber

[Avery]

Don't forget that you can get side cocking mechanisms (Rocket Cock, Spee-T-Cock) instead of rear-cocking if you want to cover up your little bolt slot, and they're a little cheaper and less liable to break or rattle and mess up your velocity, so I hear.

[liquidsoul_sm]

Actually the rocket cock has been known to break alot because it is plastic. If you are going to use nitro you should purchase a regulator. Your best bet would be a palmer stabilizer that way if you want to switch back to CO2 you will have the best reg for CO2. However, do not use Nitro and Co2 back to back. The marker will have problems. Make sure you put down the gun for about 2 hours to let all of the air cycle out before switching sources.

[in trauma]

if you go to nitro and get a screw in preset tank you dont need a reg