got a ? involves MECH

[BustNBallsKC]

ok even though im under a EVO spell right now i wanna ask everyone somthing

what will make my mech faster, please list parts and prices

also what are the dimensions of the stock dragunfly spring so i can go to the hardware store and mess around with the springs... what can i do with the spring for a lighter trigger pull. how many loops should i cut off and what do i do after i cut it? do i need to retime the gun after i make a new spring? would this be better/equal to buying a new trgger frame?

[jco]

i no of almost all of then and hav most of them but it all depends on how much money u wana spend, by the way i would not cut the trigger spring!!!!!!!:D

[jdolla]

I have heard that cutting the spring works if you do it right, and don't cut off too much. Measure it's length, take it out, stretch it, and cut it to that same length.

If you don't want to cut the trigger spring, you can get a new trigger frame for it. Cocker trigger frames fit. paintballgateway.com has a 32* Teeter hinge frame for $29.95, and some of website has a WGP Hinge for $39 or something like that, (found that link on www.dragunownersgroup.tk).

[pyromonkey]

If u had a lot of cash u could eblade it. But for the affordable stuff u caould get a new back block and a new bolt.

[pyromonkey]

also cutting the trigger spring is not as hard as it sounds, and if u screw up just stretch it some more! ALso getting a new spring or cutting it is a must as without it you would have a brick trigger pull at 2bps