TES sputters then uncocks PLEASE HELP! (already searched, no result )

[vmspimpin89]

Alright there is another thread on this and i know that but its a different problem
... ok now i was playing paintball today and my gun was working fine for a while then it started doing this dropoff thing where it shoots 3 shots then uncocks... then it stopped ... ( yes i use a pure energy 68ci 4500psi nitro tank and it was running at 375psi.... and i tried raising and lowering the psi ... didnt help ) after a while it wouldnt even shoot i would cock it and it would sputter then uncock ... i had 3000psi left in my tank... so i took out all the internals ... it all looked fine ( keep in mind i didnt know what to look for ) i oiled it and put all the stuff in then i ran 5 drops of oil thru the asa and put my tank on ... same thing ...... when i was searching i found another thread similar to this and i read it and the guy said it shot 3 shots then uncocked ... to fix the problem for him he put a lighter spring in and streatched the sear spring.... he also said the threads on the cup seal were thrashed:confused: i didnt know the cup seal had threads ... come on ppl i love my tes but im so confused.....


SHOULD I JUST SEND IT IN TO DRAGUN EMPIRE TO GET IT FIXED .....I'VE ONLY HAD IT FOR LIKE A MONTH AND PROBABLY ONLY PLAYED WITH IT 3 OR 4 TIMES ???:confused: :confused: :confused: :confused: :mad:

[wicked_one_26]

I had the same thing go wrong w/my tes. I replaced the cup seal and my problem went away. The cup seal should have threads in it.

Did the "shaft" on your cup seal put right out of the cup seal? If so, then you need a new one. You can get a tes parts kit off of ebay for about 15 bux, or goto ur local pb shop and put a spyder cup seal in ur tes.

Hope this helps u.

[20bps_tes]

sounds like the marker needs more air what psi are u runing on the inline reg

[Flakey Lemon]

Check reg out put and O-rings.

[vmspimpin89]

no its not the reg and i was running about 375 psi but i tried all the way down to 200psi and all the way up to 600 psi with the same result

Did the "shaft" on your cup seal put right out of the cup seal? does that make sense ? lol i need pics please

[TESballer]

is this "shaft" you guys are talking about a valve pin, or as in what the tes book says, a Cup seal pin...

just buy a new cup seal

[wicked_one_26]

The only reason I was using the term "shaft" is because he said he didnt really know what he was looking at. And I thought that was the ez'est way to explain what i was talkin about..........:|

[TESballer]

oic ;)

[vmspimpin89]

well i called dragun empire and they said the sear might need adjusted so i sent it to them .... when i get it back i'll post again and see what happens !!! hopefully UPS will lose my package bcs its insured for 200 dollars and i can save like 30 bucks and get a the one !!! lol

[spenny]

i have the exact problem with mine right now two and iv only used it a couple of times two soo i did what i could with it and its not the springs i took mine to the shop and got the hole thing tarred apart cleaned and re oiled every thing and the guy said thats deff. ur problem im getting my gun back tomorrow and it will be fixed ill say if its not

but i think that u need it to have all the internals cleaned and w/e and it should wrk.