can't get over 100psi

[Jordan303]

ok another problem accured for me and i searched and searched and couldn't find anything.

the problem is that i can't go over 100 psi without it leaking from the back. so i checked the fps on my chrony and it was 135....so i just shot 100 balls for fun in my backyard. when i came in i decided to check my lpr psi....its at 40 and no matter how far in or out it goes its stays at 40...:confused: ?

annyways i have a vapor valve and a 04 dye hyper inline which still havn't been brokin in yet..but i can't see that being the problem...so i tightened all screws in the solonoid. check ram orings...anyways i could play at 134 fps in 2 days cuz the field is small but i'm going to a huge woodsball game in 2 weeks and i need the distance.

any help would be appreciated


also i have a sonic lpr and a oring is half in the can someone tell me how to take it apart? againe searched and found no guides..thx

[lotus_esprit5]

For Sonic LPR info, check the MACDev forum on www.pbnation.com I'm not sure if they have what you're looking for but they might, who knows?

Take your Hyper inline off and replace it with the stock inline. If this cures it, then you have a problem with your Hyper.

Take the Sonic off and replace it with your stock LPR. See if this fixes it. If it does, then you have a problem with your Sonic.

Now just fix whichever reg is causing the problems. Take it apart, check the orings, clean any dirt out, relube.

You already tightened the solenoid screws, thats very good. Also see if the solenoid gasket is lubed. It could not be sealing correctly if it is dry. Also, if the screws are tight and the gasket is not lubed it could make it more likely to crack or get damaged.

[Jordan303]

the gasket it the silver piece that touches the body og the gun correct?

[yoda101]

the gasket is the piece of "rubber" that sits between the solenoid and the ram. The silver piece you are thinking of is the manifold