pin

[moocow90]

how the he11 do i get the back pin off the back of my rebel it wont come off

[P8ntballer]

Push the velocity adj. foward and pull hard.

[moocow90]

i tried and im not weak

[P8ntballer]

Well the reason why its so hard to take it off is usually from not properly lining up the groove in the adj. to where the pin goes in evenly. So take a cresent (I believe its called) wrench and twist the pin when you pull, it takes a lot of time/muscle but it does the job (eventually). Hope I helped ;)

[Micewheelz72]

Get something pointy, yet strong and push the gun against it on the floor...worked for me cept i forgot to put the pin back in and when I shot it the pieces flew out nd it me in the arm....ouch...

[rios]

dude, just twist the velocity holder thingy so your pin is lined up then hammer it out. after that apply lots of white lithium grease to both the pin and the place where it goes in and work it in back and forth until you can easily push it out and in. i did it and its not very hard if you have grease. hope this helps :D