AKA lpr for the T1?

[volcomboi]

I really want to put an AKA soda can 2 lpr on my T1. Does ne one know if I can buy an a front adapter block that will allow me to put one on my T1? I know zenitram makes one that allows you to put a micro rock lpr on a T1 without milling but I want an aka because they are by far superior to all other lprs. If there is an adapter please give me the website on this thread or pm me. Also does ne one know if an aftermarket ram been made for the T1? A better ram and an lpr is all I need to completely upgrade my T1.

[schoolsukz08]

No after market rams, just polish it. And yes the adapter will work with any LPR's made for cockers.

[bcsixpak2001]

I recently put a SCM-2 on my T1. I attached it with the Zenitram MRA. 1 thing you should know, it takes 3/32 ID tubing, not the 1/16 ID tubing that Zenitram tries to sell you with the MRA.

I installed an 2-Liter reg when I put on the SCM-2. Its tricky to setup if the Dragun LPR is the only LPR you have experience with (you wont understand untill you try it yourself).

I run at 120PSI and shoot about 280FPS. Only internal mod I have is a APM tigershark bolt, and im replacing it soon with a Spudnuk'l LP bolt for a little more performance.

I would also reccomend the Eclipse QEV, that shortens the spring return cycle a lot. This will allow you to increase your dwell accordingly, you will notice a difference when you get a LPR that can actually keep up with your fingers!

Good luck

[wakeupandbord]

AKALMP SCM 2 is the best there is no question, good choice