Big Daddy

[SniperM98]

Hey all you cool cats. Yo, I be diggin the SMART PARTS BIG DADDY. Does this barrel out perform all others? I want this barrel, but want some advice before I buy it though, not to make wrong choices. Does the 'Big Daddy' have excelent range, also accuracy? This is the most important buy for my marker, and I wanna go sniper. Pleaz all info will be greatly appreciated.

[kr8er]

i have a 16 inch big daddy and the range is great it shoots at least 25 feet farther than my stock and the grouping is 4 inches at 60 feet it is pretty quiet too and looks great go for it

[SniperM98]

Hey man thanx sooooo much! finally, a reply! I asked one guy about size and he say 12or 14, but I think 16 or 18 is good, you?

[kr8er]

i went for the sixteen but id either go for the 16 or 14 18 is a little big

[Icefire]

I have the 12" and it is quieter than my stock 10". The stock barrel was fairly quiet aready because of the heavy porting. At 25 feet, the AA BD does just a little better grouping than my stock (1" verse about 1/2"). I haven't been to the field yet with the BD, so I can tell you if it shoots further than my stock or not. I wouldn't go above 14". As you snipe, you may find that the 16" on up will get in the way. That is why I choose the 12". Of coarse, as a pb sniper, you wouldn't want to go below 14 either. But you also have to look a the barrel and it portings when deciding on the length. Again, for the AA BD, I would go with either 12" or 14" base on my initial observation.

[skiir360]

hey icefire i have the same gun as you...what paint did you find works best with the 4.0 stock barrel. a lot of mine is still curving..might be too cold but i aint sure.??

[Icefire]

Skiir,

I use 32 degree team colors. It work very nicely for my Big Daddy as well as the stock. The team colors are medium bore, think shell, thin fill pants that should work pretty well for you in cold weather. I used it in 45 degree weather yesterday and didn't have any breaks in the barrel. It also produced a faily tight pattern with my BD at about 75 feet.

[skiir360]

ok maybe my paint is too small... i use proball and that is a smaller bore,, that might be the problem

[pwrov1]

Anyone have some more info? Thanx!