98 custom with Palmer male stab question

[chrishaolin]

i am attempting to put my palmer male stab on my 98custom. after screwing it in fully, the stab's input port is facing "out" (that is the direction the barrel is pointing).. if i loosen the stab so that the input port is facing in, the stab is loose and shaky, and i can see this being a pain as a fore-grip.. any ideas??

also, i am attaching a PB drop forward with the male palmer stab. what type of elbow(s) and hoses do i need? i would rather not use macroline.. i would like to be able to use the tippmann stock hose. thanks alot! :eek:

[liquidsoul_sm]

You will not be able to use the stock hose. You will have to purchase something smaller. WIth the pyscho drop you willl need two 90 elbows. Probably about 3 inches of steel braided hose. Using this setup I really think macroline would be a better solution, but it is up to you. You can purchase those parts at countypaintball.

[chrishaolin]

Originally posted by liquidsoul_sm
You will not be able to use the stock hose. You will have to purchase something smaller. WIth the pyscho drop you willl need two 90 elbows. Probably about 3 inches of steel braided hose. Using this setup I really think macroline would be a better solution, but it is up to you. You can purchase those parts at countypaintball.

i have a macroline kit that i got from countypaintball, but i only have 1 90* elbow, so i will have to get another one. I was trying to figure out how the macroline hoses attach to the ports.. do they just slide in or screw in?

[liquidsoul_sm]

You push the macroline into the fitting after you have cut it to the necessary length. Then pull out the macroline slightly, this locks it into place. And thats it!