Problems to look out for?

[DBake]

I'm getting my first shocker "2000 Vert Shocker with Glacier Board" What are some of the problems to watch for?

DBake

[Sid]

Don't use Co2. Yes the max-flow can handle it, but I would definitely not recommend putting co2 through your gun.

Just make sure you clean the reg and grease the bolt as per smart parts instruction manual.

[DasBaldDog]

No offense Flash, but Smart Parts actually recommends using co2 on Shockers. If you have a anti-syphon then you will have no problem with liquid in the gun. The maxflow has a bleed-off capacity.

[SHOCKYOU]

Although Smart parts said it was made to run off Co2 I find that it runs a lot better off nitro, as would any gun. But i see more consistent pressures, ans well as less down time waiting for enough pressure to fire again.

SHOCKYOU

[Halliday]

Make sure to clean it like it says in the instructions. Use co2 if you have to, but try to use HPA. I looked at it like this:
co2: fine for rec days
HPA: tourney
Have either a Freak set or diff bore barrels. The bore size really makes a difference in performance.