What the Hell....!!!!

[A damn fool]

I just had my timmy relooked at by my proshop because it was leakiung again. Its called paintballplus, and they took a training course on the gun with bob long. The went through everything, and it still doesnt work. They replaced o rings, the cup seal, and it leask down the barrel. And even wors,e the entire valve assembly seems to be pushing back, like where the knob goes in to keep the striker in, that whole assembly moves back when gased up. What the Hell is going on?

Im sending it back to bob, just wondergin if ne knows wh this is doing this?

[CountyPaintball]

There's a set screw to hold that assembly in place. Sounds like they didn't tighten it back down enough. Also, Bob uses red loctite on it to help hold it there. The set screw just sits in a slight recess. If they didn't use the loctite, it may have come loose which allows it to move.

If it leaks down the barrel, you may want to try a black magic cup seal for the Intimidator. I had a gun that wouldn't stop leaking with the stock seal. The black magic took care of it.

Mike

[A damn fool]

Well, i jsut called delta. Apparently, theyve had a lto of problems similar to mine. They have a new valve sleeve i guess, and they told me to send it to them, and they'd replace it. They said its wider or soemtihng, and never leaks

[Marauder]

good ole delta :)