What do I need...

[cheddar]

Okay, so I'm going to end up getting the b2k4 with pds on it...$500 is the best deal I have seen. So that leaves me with $150 to work with replacing some stuff that needs it.

I believe I need a dropforward for it...but what type should I get (I like the stock drop that my electra has...though it is a piece of junk, it does put my tank where I like it - about half under the gun half behind).

That'll cost me what? 30 for a decent one?

So I now have 120 to work with. Ditch the stock barrel for a cp 2 piece? That'd be another 40-50...putting me at 80.

So the question is ther eanything else I need for the gun? Or what's the next thing I should look at replacing...bolt? valve? chip?

[I run a e2 with z board if that helps...]

Again, any input is very welcome

[yoda101]

I would go inline reg before i got a valve. Look at a CP Reg or if you want to spend a bit more a sidewinder or 04 gladiator

[kl1223]

This is what I would do:

B2k w/ PDS: $500
Unimount: $35
Cp 2 pc: $60
CP reg: $65 I think

That's a nice setup and leaves you with about $20 to pay for shipping.