Yay! More reg problems! And one more mystery problem!

[Flakey Lemon]

So I get the ol' tank filled today, i screw it in my bko, poof! A barrel leak, that was easily fixed my flipping the valve around. I screw in the tank again, a barrel leak, I fix it by adjusting the LPR. I take a shot, and to m surprise the darn thing wouldn't recock. I had to pull the bolt pin back to get it to recock, I take another shot and I got the same thing. I finally get it loosened up afte about 15 minutes, i fill my hopper and start shooting, I get crazy drop off even though my reg is at 250 psi - 275 psi. And then the bolt was only going foward about an inch. Please help me before I throw this darn thing in an insinorator :D

Thanks,

Lemon.

[ShootPaint]

Try loosening the two screws that hold the ram assembly in place at the rear of the marker. It sounds like either your ram or bolt is binding causing the marker to stick forward or not go all the way forward.

[ImpYa]

Originally posted by ShootPaint
Try loosening the two screws that hold the ram assembly in place at the rear of the marker. It sounds like either your ram or bolt is binding causing the marker to stick forward or not go all the way forward.

I agree.

[ShorTi]

Same thing happened to me, the ram screws were to tight but then I stripped them, just be careful losing them.

[puck2paint]

either the ram screws, or the allen screw under the blue tube by the solenoid (whats that thing called? I keep forgetting) that might be loose. it should be snug