ram not returning all the way back.

[avbrann]

At times the bolt does not return all the way back when firing paint. Dry firing i dont have the problem. When it doesnt return all the way, i pulled out the bolt to look down at the ram, and it was a held forward a bit.
I tried greasing the ram thinking maybe thats what it needed. but same problem persists.

[ShootPaint]

IF you have a BKO try loosening the two screws that hold the ram housing in the marker. Sometimes these screws can be over tightened that will cause a problem with the marker recocking.

How did you lube your ram? Did you remove the end cap and lube the ram or did you simply put lube on the ram shaft?

To properly lube your ram you need to remove the end cap and get grease down the entire ram assembly, then work the ram back and forth to spead the grease out. Once this is done whip away any excess grease.

[avbrann]

just the ram shaft, and the hammer.

Ithink its the hammer thats getting stuck in the body.