help!

[dragun1217]

oki firstly my led light came out and went inside the gun i can still see it but i can seem to get it out enought to put it back in correctly how do i do this without taking the friggin thing apart and i got paint in all of thesse grooves i cant reach hopw do i clean it? gun is in sig.

[BunkerBuddy_666]

U have to take ur marker apart for that.

[lotus_esprit5]

dont be afraid to open your gun up. you just need to be careful with the wiring, but its really not a big deal.

For the LED, just unscrew the tray of your gun (the 4 screws in the bottom of the gun), remove the tray from the gun body, and push the LED back into its holder.

For cleaning the paint, just take the gun apart. Thats about it. Try using a Q-tip for getting into corners and stuff, they work well.

[dragun1217]

thx so much and also is there a way to keep the led in place so i wont fall out nemore?

[ShorTi]

It shouldnt but you can try super gluge. But if you do that just use like a dap, or put some on a toothpick and dap it on the LED.

[dragun1217]

will this make it hard to install new led lights if i super glue becasue when vaporworks does my pds dont they put in a new led light?

[ShorTi]

Well if you plan to get it vaporized soon then don't do it, but if you are waiting a month or two put some blue loctite on it.

[dragun1217]

wait so u mean just put loctite on the side of the light where it touches the holder thing?

[ShorTi]

Yea, but don't glob it on there, just put enough to hold it in place but it isn't noticeable.

[dragun1217]

thank u so much shorti for ur help!!!

[ShorTi]

NP