pr0kch0p
12-17-2001, 05:08 PM
I was playing on saturday and i was setting my regs for the first time after greasing my timmy. I was having a lot of trouble getting the pressure right and chronoing it.
first of all i could barely get my LP reg below 100psi. the adjustment screw on the reg is almost backed up all the way, it is sticking out about 1/4". now it is at about 75psi
the HP reg is set at 300 psi and the screw on that is also backed out pretty far, not nearly as far as the LP though. my input is about 400PSI
my FPS was all over the place and i got a low first ball a lot of the time. my FPS would go from 96 - 276 - 190 - 250 - 189, etc.
BTW i was shooting midnights and they were rolling out of the barrel, could that be leading to the consistency problem? my efficiency was horrible too.
What can i do? If i need to send it in somewhere now would be the time to do it since i am going on vacation for 2 weeks over winter break so i wont be needing it.
Thanks.
first of all i could barely get my LP reg below 100psi. the adjustment screw on the reg is almost backed up all the way, it is sticking out about 1/4". now it is at about 75psi
the HP reg is set at 300 psi and the screw on that is also backed out pretty far, not nearly as far as the LP though. my input is about 400PSI
my FPS was all over the place and i got a low first ball a lot of the time. my FPS would go from 96 - 276 - 190 - 250 - 189, etc.
BTW i was shooting midnights and they were rolling out of the barrel, could that be leading to the consistency problem? my efficiency was horrible too.
What can i do? If i need to send it in somewhere now would be the time to do it since i am going on vacation for 2 weeks over winter break so i wont be needing it.
Thanks.