adrenaline frame

[oddballer55]

i was wondering how to adjust the new Al frame since my local shop didn't have a clue on how to do it...i want to make it a lighter pull also

[Smartpart5]

well if its a regular AI frame this is what i did, i took the frame off, then removed the board and then the trigger pin. i got the whole trigger out the drilled the magnet out, then just put it back in presto. it made it one of the nicest frames i felt.

im not responsible

[Dr J]

I've only had one apart (and that was enough for me) but it seems to me that there's only 1 adjustment. (or none) I ended up giving the owner a free trigger job, which consisted of some electrical tape between the magnet and the trigger/body. made the pull a little shorter and lessened the effect of the magnet.

I hate AI frames and I'm not responsible for your hate of them either.

[oddballer55]

yea well it's the new frame and on their site it said you can make it as weak or strong as you like, i've still yet to figure out how to do this... Dr. J how much tape did you put between the magnets?

[Dr J]

not much, just a couple layers

[oddballer55]

so how do you get the board off from on top of the frame?

[toothpastedog]

Originally posted by oddballer55
i was wondering how to adjust the new Al frame since my local shop didn't have a clue on how to do it...i want to make it a lighter pull also

The new trigger frame is fully adjustible, and will perform just as well, if not better than any other new grip frame.

The new AI frames are called AIM frames, and have three points of adjustment.

[oddballer55]

ok so where do i adjust it to make it a lighter pull?

[toothpastedog]

just to make sure, do you have the AIM frame, or the older AI frame?

http://www.buypb.com/wdetail.asp?product_ID=ADR-ImpFramDb-9002

[oddballer55]

the new one from buypb cuz i just got it from them?

[toothpastedog]

just check out that link