03e Lpr

[bullski]

Could to little LPR pressure result in chopping(with eye on) or slower bolt movement..?
Because when i adjust the LPR,i just take it all the way out and slowly screw it in,until the bolt cycles,but it chop with eye on,then it may not cycle forth all the way...?
As it was written on another thread about the setup on the 03e: turn the LPR in,until it leaks,and then screw it about 1/4 turn back and let it stay there,and in later adjustments(chrono,balls) then only use the HPR to adjust?

[jcabes]

It shouldn't result in chopping, obviously since the eye should know that the paintball isn't chambered, but it could result in a pile of paintballs in your barrel that are past the breakbeam eye. If you don't have it high enough, there won't be enough pressure on the bolt. Just take the barrel off when your doing this and a few may just spit out.

[bullski]

but when i try to screw all the way in(before leak),it used more air then almost nothing LPR,so shall i try to screw a little more out?
Can i get many balls out of a 47ci/3000 psi 0,8 l psi bottle at the right adjustments?