i just recently bought....

[dingleberries]

a rip valve. but could someone give me the directions on how to install it and where it goes ect.

[toothpastedog]

Installation Instructions:

Installation is easy but will take some time. Don't let the number of steps scare you. I tried to be as detailed as possible. Remember both technical and not so technical people read the Impulse FAQ (but all are Smart!!)

1. Degas the marker.
2. Remove the bolt pin and slide the bolt out the back of the marker.
3. Remove the valve cap.
4. Once the Valve cap has been removed, remove the valve spring and valve.
5. Unscrew the hammer assembly from the back of the marker
6. Remove the two screws that hold the grip frame and solenoid tray to the body.
7. Separate the grip frame from the body. If you have a non-Vision Impulse be careful when removing the grip frame and solenoid tray and remember to disconnect the board from the solenoid.
8. If you have a Vision Impulse, you will need to remove the ball detent on the eye side of the marker as well as the eye cover. You will also need to disconnect the Vision eye board from the solenoid and then remove the two screws holding the Vision eye board in place.
9. On the underside of the body is the screw that holds the valve Seat (Valve Body) in place. Remove this screw.
10. Push the stock Valve Body out the BACK of the Impusle. It will not fit out the front.
11. Slide the included o-rings onto the High Flow Valve. Lube them with some Dow 33.
12. Insert the rounded side first into the back of the Impulse. When installed correctly the hammer will come forward and hit the little dimple shown on the left side of the picture above. Make sure that the ramped hole is facing up and the solid hole is on the bottom.
13. Push the High Flow Valve up into the Impulse until it lines up with the hole in the bottom of the Impulse body.
14. Screw in the valve screw so that it is flush with the body.
15. Put the Valve Cap back on. Do not put the stock Valve Spring back in.
16. Since it is out, clean and lube the hammer assembly. Then screw that back in place.
17. If you have Vision, install the Vision eye board, eye cover and eye side ball detent.
18. If you have a non-Vision Impulse, connect the solenoid to the board.
19. Attach the solenoid tray and trigger frame to the body.
20. Put the bolt back. Make sure it's not upside down and make sure that the bolt pin catches the hammer.
21. Last step, load it up and enjoy!!!


Thanks wolfy ;)

Just make sure to install the valve from the back of the impulse, and put plunty of dow33 on the valve's two o-rings.