PSI Range of Eclipse Impy

[AdrenalynFreek]

I have an Planet Eclipse Imp and I need to know what the psi range of it is. I know its low pressure but could I use 450 psi, what?

[dingleberries]

pretty much ALL impulses run between 100-200psi in operating pressure wise. there are a few varibles that could effect this like current setup or upgrades and such.

but do you mean, if you could use a nitro tank that has a output of 450psi?

if so, this is ok, but i would recommend a tank output of at least 800psi. you can get this in any high pressure tank.

but we need more info. what do you mean?

we are not mind readers, open up alittle more

[wordf0o]

No matter what, use a HP Nitro tank.

What reg do you have?

[ikey]

you can use anything. but if you have an option, get a high pressure tank. if you have an adjustable tank, put it at like 650 psi. 450 will work fine, even 200 will, but the maxflow works its best at around 650 psi.

[toothpastedog]

well, an input of 200psi will give the maxflo a very hard time, and as a result the gun will be very inconsistant and unaccurate. Basically, again, any tank output above 400psi will work, although the best is 600-900psi. The gun needs an inline reg to function though. the inline reg regulates the input pressure from 120-200psi, depending if you have a tapeworm, vff/hfv, or an lpr setup. Co2 will also work fine on impulses, just as long as you use an anti siphon kit with the tank/asa-if you don't, you'll end up destroying your solenoid and all internal seals, cost you about 100$ to repare.