Uh oh

[mr. lobster]

Alright, got my impy yesterday from FOM, you can see the setup in my sig. Anyway, i screwed in the 20oz co2 (w/ on/off and anti-siphon of course) and turned it on, it promptly started venting spurts of gas out the brass vent in the front of the full flow, while the reg went all the way up to 250 :eek: So I turned it off, screwed the reg almost all the way down and gassed it back up, started screwing up the reg, but it started venting at about 100 I kept turning it up and the venting stopped, but couldn't get the pressure high than 120 and it wasn't firing. I had also removed the bolt which was sliding freely, when I replaced it it seemed locked in place with the pin all the way back. Also, the blade trigger had the lower screw hitting the back of the frame, and I couldn't hear the solinoid clicking and the LED did not flash when trigger was pulled. is this screw part of the problem?

sorry about the long post, but I could use some help :confused:

[PBSouLjAh]

dam u really screwed it up. hm try askin FOM, i dont know much about full flows, but hopefully you'll get it fixed, i love my impulse i just bought.

[Killer Kat]

I would start at the begining again, I'd also relube the hammer assembly. Make sure when you put the bolt back in the large hole is pointing down. There is also a little groove or sleeve directly behind the front of the hammers "face or top" make sure the bolts pin goes in this notched area , and not in front of the bolt. Start right at the same point on the reg, is you r co2 tank full?

[mr. lobster]

hey all fixed, no biggie. just adjusted the back screw on the trigger, that fixed the trigger. And my co2 tank was almost empty, hence the lowe pressure. Thanks for the help anyhow.