Stock for m98c ?

[Tippmannmann]

Were can I get a stock that is less then $30 maybe what would be like a submachine gun stock. (not to make it look like a real gun just I think there comfly)

[Schwartz]

I dont think that you can.
The ProTeam Car/Stock will run you about $80 or $90
The Voodoo folding stocks go for about $40 or so.
(The Voodoo is my recomendation)

[Tippmannmann]

do you have a site were I can locate the "vodoo", thanks

[Schwartz]

I dont to tell you the truth. A friend of mine has it, and it is a very cool looking stock for his Tippmann. He bought it about a year ago.
Ive looked online to try and locate one myself, but havent had any luck (im not sure who the manufacturer of it is)

If i do find any info out, i will be sure to post it on this thread for you.

[Tippmannmann]

Does it mount on the back of the gun? because I dont like the ones thant mount with the bottom line.

[Schwartz]

The Voodoo mounts on the bottom of the grip on your tippmann.
and it folds in and out as needed from there.

The ProTeam Car/Fx Stock mounts to the back where an RVA normally would be.

I have 2 friends with stocks: one with voodoo, one with Proteam
and to tell you the truth, i think the voodoo is much more comfortable.

[Tippmannmann]

ok Ill check it out I just need a site to look at it.

[Tippmannmann]

does anyone know the site were I can look at one?

[paintbrawler]

www.countypaintball.com sells them both, but there is no pic of the voodoo stock.

[JDS]

I made mine out of 1/8"x3/4" steel bar stock. Picked up the 36 inches of bar stock at Home Depot for $2.25 drilled to holes to match the ASA bolts mines about 12"-14" long. I bent the bar down for about 4" then bent it back up about 6"making a curve in the butt of the stock for comfort, then bent it back around to the gun/horizontal part of the stock. You will need a longer rear bolt for the ASA connection, I had one but you should be able to pick one up for .20cents+/-. The bar stock is bolted between the ASA and the bottom of the grip. I bent the bar stock using a vise and by hand, then painted it camo to match my M98C. There is a post of a simular stock at M98center.com to bad I found it after I did mine. They put a small hook on the bottom so you can hang the gun. Mine bends all the way around and it doesn't need it but when I get the chance I'll have a friend with a welder give it a zap where it bends back to the horizontal part.

[gsupanther]

there are some at ebay and there should be a post I did a while back it should be on there.