Installing the HP valve stem

[Z315]

Where is that HP Valve Stem soupose to go? Anybody got like pictures so my installintion can go a little smoother? Thanks~! HP Valve Stem

[TESballer]

i don't have a camera so no pictures, but if you have the manual the exploded view of the the tes on the last page will help

first you unscrew the screw(#37) that holds the front block(#49) in place

once unscrewed just pull the front block(#49) out

if your gun still has the stock reg, and drop on it you might have to remove the gripframe, so you have enough room to pull the front block out

after the front block is out pull out the cup seal spring(#48), cup seal(#46), and cup seal pin(#45) all of them should be attached to each other

you are replacing the stock cup seal, and cup seal pin, with the new HP valve stem

all you need to do is put the cup seal spring off the stock part, and put it on the HP stem, after that put the HP stem (with spring attached) back in the hole on the valve(#44), and put the front block and screw back on your gun