MNsniper
01-08-2002, 07:59 PM
there are 2 o-rings that are on you valve, where you put your cup seal. then there is one on your hammer and 2 on your bolt. if you take the valve out (take off your trigger frame and remove the gold screw first) and look at how the cup seal and the valve match up you should be able to tell up it's bad. also look for chips or dents in the valve and cup seal. it sounds like your cup seal got stuck, so next time try putting a drop of oil on your valve pin. and make sure the spring is on right. also make sure your LP chaber is on correct. i don't know how many times my friend cleaned his gun then put air into it and wasted half a bottle cause he forgot to put on the LP chamber. also check the orings on the block where the tank would screw in if you use the tank vertically. if that doesn't solve the prob, take it to your local dealer.