Intellifeed

[DeadVenom]

I went to www.wdp-paintball.com

and no instructions to install the intellifeed

does anyone know where i can find it???

[wolverine]

There are instructions in the tech section at www.g3pb.com

It is quite simple, but you need to be able to solder.

To connect the wire to the Revy
1. Open up your revy.
2. Remove the cap from the bottom of the motor.
3. Cut a small hole in the motor cap and one of the revy shells. This is where you will feed the wire from the motor to the back of your Angel. Remember to measuer twice and cut once!!!
4. Solder one wire to each terminal on the motor.

To connect the Intellifeed site rail to the Angel LCD
1. Remove the stock site rail.
2. Remove the back plate. Becareful and catche the breach rod spring!!
3. Remove the grips.
4. feed the intellifeed wire down through the top, behind the solenoid and to the board.
5. Plug it in.
6. Mount the site rail.
7. Put the back plate (with spring) and grips back on.

Connect the intellifeed Revy to your Angel and turn it on. During the startup process the revy should spin. If not, something is not connected correctly.

Remember that the Revy will now run on the Angel's battery and not 9v batteries. DO NOT put batteries in the Revy and attempt to use the Intellifeed at the same time. If not installed properly you will fry the moror or the board in your Angel.

[DeadVenom]

thanks man

needed it!