air leaking

[2k3cocker]

im all new to impulses and i finally got done my trigger and aired up my gun and it leaks out of the front reg from this brass fitting thing not sure whut it is and the guage goes up to 300 psi on the reg n air is shooting out n i unscrew the tank a lil and the air stays in but shoots once n doesnt re cock and air doesnt go back in it does anyone have any idea whut i should do??

[ikey]

yeah um why is your pressure at 300, you made your prv blow, your pressure should never be above 200-220. after 220 stuff blows (like prvs). what internals do you have. with a stock valve put your pressure at 180 and set dwell, with a RIP valve set dwell at 14-150ish depending on what parts you have.

[jokerdude1333]

LOWER THE PRESSURE NOW, take the pressure down to around 180. 300 is WAY to high, the little brass thing is the PRV pressure release valve, it will let air out when the pressure gets above 200 or so. the pressure should never be over 200. if you dont know how to adjust the pressure then go to www.smartparts.com and get the manual. hopefully you didnt bow your noid. to turn the pressure down, turn the thing at the bottom of the max flo clockwise.

[ikey]

yeah i hope you didnt blow the noid. if you didnt you got lucky cause 300 is about 120 psi more than it should be. dude judgeing by your name 2k3 cocker, if you own a cocker you must be able to turn the pressure on a reg up and down. all you gotta do is twist the bottom of the maxi. all the wat out or loose is lower, screwing it in turns it up.

[2k3cocker]

alrite thanx guys yeah i had 2 cockers before n other guns never had an impy its my firts one lol thanx u guys definetly help out alot alrite it worked and for some reason i will shoot a few shots and the air leaks out the back of the gun like abover there the board sits in that area whut could that be blown o-ring or something???

[speedy2k4]

unfortunately, it sounds like you did blow the noid. remove the trigger frame, and check and see if it is leaking from the solenoid. if it is, remove the solenoid and try greasing the rubber gasket between the solenoid and body. if that doesn't stop the leak, pull $60 out of your wallet and call it a lesson learned.

[ikey]

dude, i know its kinda late, but didnt you read the manual or do anything ot learn how this gun worked? not all guns work like autocockers. man it would be a shame if spent like 1000 bucks and did that to a timmy or something.

[toothpastedog]

Originally posted by ikey
dude, i know its kinda late, but didnt you read the manual or do anything ot learn how this gun worked?

no :rolleyes:

[ase]

http://www.smartparts.com/Manuals/Impulse.pdf

[toothpastedog]

Originally posted by ase
http://www.smartparts.com/Manuals/Impulse.pdf

good god, a manual... better not read it concerning i'm gonna spend 400$, and since i'm a man, i definitely shouldn't read it, nor ask for directions... :rolleyes: :P

[CoolT]

Manuals rock. Searching also rocks. :tup: