tray

[Some_Impy]

alright i am in the middle of putting in a new trigger and i wanted to take off my tray so i unscrwew that screw but it only came loose and wont come off. When i wiggle it, it seems that the stock trigger is keeping it in place is this possible?

Can someone give me a solution?

[impy1511]

there are two scerws i belive holding the tray to frame. You have to tkae off the board to get the other one. I dont think htat the trigger keeps it in place, at least thats what i think

[Awhislyle]

Ok o you took out the two screws holding the tay and frame to the body rght?

Then disconnetc the solenoid from the board, then unscrew the screw holding the frame to the tray, it is right under where the solenoid plugs into

3 screws total I believe.

[Some_Impy]

alright so what exactly do i have to do to get to the point were i install my tirgger? do i have to mess with those blue rubber things?

[Some_Impy]

alrighty i took all the screws out of the board now the thing wont come off..?? the blue things are all disconnected also.

[Some_Impy]

problem solved

[toothpastedog]

any more issues?

[Some_Impy]

man ive been having all the bad luck lately but right now just my cricket board light isnt showing

[toothpastedog]

so when you turn it on, does it blink? when you shoot, does it blink? sucks to be you :P

[Kurama]

Adjust your trigger. No flashing or sound at all usually means the actulation screw (top of trigger) is screwed in too far and not allowing the switch to move. Or it seems like that when I adjust my trigger.

[Some_Impy]

Oh S*** your right...i screwed it in a little to far just because i was trying to get it working and i am trying to do this by reading the step by steps. anyways ima screw it down a bit and go try what tpd told me on the blue cricket light post