how to install a valve

[daredevilj11]

how do you install a vapor valve in a 2003 bko?

[lotus_esprit5]

remove the Volumizer. Let the valve spring, spring guide, and valve pin slide out the front of the gun. Then remove the tray of the gun, the inline, and the front block/ASA. Look at the bottom of the gun body, you should see a screw in the bottom of the body. That is the valve set screw, remove it. Then remove the ram. Insert a pencil into the ram shaft (eraser first) and use it to push the valve out the front of the gun.

Now that you have the stock valve removed you can install your vapor valve. slide the vapor valve in, and when you do it there are a few things to make sure you are doing.

1)have the valve facing the right direction. The valve should be in there so that the end with the wider hole is facing toward the volumizer.

2)If you look at the side of the valve you will see an indented circle where the valve set screw is supposed to lock it in place. Make sure this indentation is facing down.

Once the valve is in place, replace the valve set screw (wrap it in teflon tape to make sure it doesnt get loose when you're playing) and reassemble your gun. :tup:

lol it sounds way more complicated than it is. You basically just take your gun most of the way apart, remove stock valve, replace with Vapor valve, reassemble. its really easy. if you need any clarification on how to do any of the stuff above just lemme know, I dont know how much of a noob you are so I dont know how in-depth to make it :D

[daredevilj11]

thanks alot, i can picture how to do this in my head...