Dragunfly T-board help

[oELEPHANTo]

I recently purchased a T-Board for my Dragunfly LED and I am having trouble with the wiring. Does anybody know the proper way to insert the wires?

[soundman]

http://www.scenariodreams.com/manuals/dragun_install2.doc

sol is the yellow wire the rest you should be able to figure out. My suggested programing is defult then turn on or off the eyes depending on your setup then valve on and valve mode adjustible and it should ripe.

[DarkeWolf]

ummm....my d-fly led doesnt have a yellow wire? do you mean the leads that run up to the Electric Solenoid? on mine, those are silk braided.

[soundman]

Yea yellow insulation, the wire coming from the front of the gun goes to VAL .

[DarkeWolf]

ah, ok, so that would be the leads to the Pneumatic solenoid/5 way.
hmmmm good to know, I'm having a bit of probs wiring a lcd dragun board into my led dragunfly, because they arent labled, on the led.
heh...now if I can get those damned screws out......

[oELEPHANTo]

Thanks Guys! I got it all wired up.

[oELEPHANTo]

Originally posted by DarkeWolf
ah, ok, so that would be the leads to the Pneumatic solenoid/5 way.
hmmmm good to know, I'm having a bit of probs wiring a lcd dragun board into my led dragunfly, because they arent labled, on the led.
heh...now if I can get those damned screws out...... Ha yeah, I had problems with the screws also.

[DarkeWolf]

yeah, my problem is that I dont have a screwdriver small enough, that goes deep enough to get in there without stripping them out.

[oELEPHANTo]

I ended up just tearing out the board then dremelling the screw out.

[DarkeWolf]

ouch!

nah, I'm just gonna get some jeweler's screwdrivers and get them out. I just keep forgetting to buy them anytime that I am someplace that has them.

[oELEPHANTo]

Well I was just getting REALLY agrivated and I didn't really care that much since I already got the new board.