\\\- Enigma EXR Low Pressure ... Springs? -\\\

[jade]

ALL LP CONVERTED GUNS post here!!! (doesn't have to be an enigma)

Here's the setup:

Enigma EXR (kinda like the spyder shutter, core sharc, etc.)
Lapco Cup Seal
32 Degrees Valve & Pin
32 Degrees 16 Terminator Barrel
JAVA Gauge
Modified Bolt
9V Revy

I was hoping to tweak my pressure for maximum efficiency, so I read up on lightening your springs. What improvements has it done to your gun? Plz list your gun specs too (doesn't have to be an Engima). Does anyone know a spring set that will fit or work well with an EXR? The spring is pretty small in diameter; almost like the size of a pen's spring but a little bigger.

Also, should I upgrade my Revy with an X-board? Does the 12V revy really make a big difference? Since my gun is only semi, I figured only autos would use a 12?

[tacoboy]

im very curious about going LP with my enigma too, can the reg it came with go LP, im thinking no...? what else would i need?

[jade]

Why would u think it wouldn't work? I'm currently running the gun off of that and @330-400psi (still tweakin).

To go LP with this gun...
Get a barrel with little porting
Small bore with good paint size to match
Turbo Valve
Pin
Cup Seal

Our LP chamber is quite large, so it should do alright. The airflow in the gun is pretty good. I modded the bolt a lil to help push a lil more air out of the gun. You can copy my gun config if ya want. Just as long as I don't see ya on the field, hehe =).

[tacoboy]

cool cool, my bigshot is 1 town away, so that should get here tomorrow, which way do you turn your reg to lower it, and do you oil it? sorry i havnt done like anything to my reg :D

[jade]

Well, you shouldn't mess with the regulator unless you have the required mods. You can't go LP w/o em. U turn the reg clockwise to lower it.

Oil the reg? Do you mean your gauge says Use No Oil? To oil your gun, just put 3 drops of oil in that little hole where you put your CO2 tank. Take ur barrel off and dry fire a few shots.