sputtering problems

[cockercrazy88]

my friend has a 03 vision impulse with cricket board and tapeworm, the gun turns on fine, but when fired it just sputters, we have tried adjusting the pressure and it still didnt work...any ideas?

[speedy2k4]

is the bolt upsde down? was the tapeworm installed correctly? Is it properly cleaned/lubed?

[cockercrazy88]

no the bolts fine,yes,yes,...........it worked before, and then all of a sudden it started,

when i pull the trigger the bolt goes back about 1/2 and inch and a lil air comes out

[speedy2k4]

normally i would say your lpr was too low, but you don't have an lpr. you are sure the input pressure is high enough? and the tank is full?

[cockercrazy88]

yea, i took up to my local shop, and they said they didnt kno wut was wrong, they said there best bet was the board, but then i duno about that

[speedy2k4]

what is the dwell set at, and why can shops never figure anything out?

[cockercrazy88]

im not sure how to change the dwell, and thats cuz most local shops are set on selling stuff to noobs, and learn about spyders cuz most people who play have a spyder

[speedy2k4]

on the right side of the board there are 2 buttons, the one at the front turns the dwell up and the one near the back turns dwell down. try setting your input pressure to 180psi, and then try turning the dwell up and see if you can get it to shoot correctly.