Need Angel Help Asap!!!

[kdneo]

I have an angel LCD 2k1 The top piece that the hopper drops into has been determined to be stripped. The part that is stripped is on the body itself (hope ya know what I am talking about) Anyone know what I can do to fix this, or where I can get a body? (prefer to fix it though) I have a tournament in 2 weeks, so something has to be done.


Anyone got an idea?

Thanks

Mike

[dager]

depending on how bad the threads are striped you have 2 options.. you can try loctite (red or stronger) if the threads are still somewhat in tact.. if they are completly gone make sure you have the feed tube you want and you will need to pick up some JB Weld from your hardware store.. make sure that you clean off any excess before it hardens bacuse once it sets its on for good

-duff

[wolverine]

I have found that if you get a brand new feed tube (you know "top piece that the hopper drops into") and then loc-tite that in you will be ok. Normally if the body is stripped, so is the threads on the feed tube. A new Feed tube will give you more grip, but you will still need to loc-tite it in.

[kdneo]

anyone got other ideas rather than glueing it in?

[wolverine]

yeah, get a new feed tube and use loc-tite....I have seen this work.

what I am chopped liver??

[kdneo]

lol, no no no, I was just looking for any other options that were out there. I was hoping not to have to glue that sucker in there, but oh well. Thanks man

[wolverine]

I was just messin with ya. :D