ACI Expansion Chamber

[MuckRaker]

Just got my ACI four stage in today ... attached to the gun, no problem. But, is there an easy way to rotate the hole so it lines up with my Bottom line? I tried everything short of putting it in a vice and wrenching it around. Any suggestions would be greatly appreciated.

[MuckRaker]

hmmmm .....

[MTU_Paintballer]

everyone that i know who has an ACI Expansion Chamber just got lucky and had to hole line up. Good luck and hope you figure it out.

[Halliday]

Wrench the Mo-Fo! Or use the hole on the bottom. I don't own one but I think there is a port on the bottom.

[Edited by Halliday on 04-02-2001 at 09:39 PM]

[Jordan]

wasnt there sumone else witht tthe same problem?

[MuckRaker]

yeah, i tried to find that post but couldn't ... there's a large hex nut (allen wrenchable) on the bottom of and at the top, just below the threads, there's a couple of indentions that look like a big Arse wrench could get hold of ... I guess, maybe, the vice is needed ... hopefully I won't break the dam thing.

[MuckRaker]

Of course I had to call ACI ... Rep said to take a cresent wrench and secure it around the top of the chamber, just below the threads (there are two flat indentations) and put an Allen wrench to the Hex nut at the bottom of the chamber. Losen the Hex nut while firmly holding the cresent wrench. Once loosened, attach the chamber to the marker and rotate the plastic housing (with the hole in it) until the hole is where you want it. Take the chamber off the marker and tighten the hex nut. then reattach.

[Halliday]

Too cool. I did not know it could rotate like that.
I might just have to pick one up for my Mag.