Finally Got It

[Button Mash]

i got a stock today (Tapco) and i have no idea how to put it in...i assume unscrew the back but iam affraid the spring will fly out...PLEASE HELP

[REVOLV3R]

1. Take gun apart
2. Take back cap off
3. Put the front of the stock where the back cap was(when you take the cap off you will see what I mean)

[Paintballrocks]

Spring wont shoot off promise me your gonna have to take the gun apart plenty of times after that you take it apart the first time itll take you no time at all. The end cap(plastic) will pop up and off with little to no effort at all.

[jpen2008]

Make sure the gun is in the un-cocked position.

[Button Mash]

k well i cant do any damage to my gun when i take it fully apart can i?

i have never done that b4 so i dont wanna **** my insides you know?

[jpen2008]

No you should not do any damage by taking it apart inless you drop it off ur roof then maybe somthing might happen. Just take all the receiver bolts out then make sure the gun is not cocked. Leave the feed kneck elbow on so that the site spring dosnt shoot off somewhere. Then i take a screw driver and pry each end of the gun so it comes off more evenly. You might want to clean all the oils and dirt out of the gun or just were the bolt is and put new oil in if you have used it and never cleaned it it is good practice.