Too tight or too loose?

[Pig-Demon]

Me and my dip**** friend, baddy1121, are having an arguement. He has a multi switch barrel system and i think he is matching the inserts wrong. He likes to match paint so that it goes thru the barrel very easily or even sometimes falls thru. I think that he should make it make it a little tighter so that you have some difficulty pushing it thru.

So the arguement is: what is better? a little to tight or a little to loose?

[PoYsYn]

TIGHT, LOOSE WOULD CAUSE MORE BALL BREAKS!!!:mad:

[splatterpunx]

its simple place a ball in the insert it should fit snug but not tight
then blow through the insert the ball should shoot out with a
easy blow,if the balls are falling through or loose the bore is to big
and they shouldent cram in either.

[baddy1121]

exactly

beyond that, I dont want the balls to roll down the barrel
I would just rather have it a little loose than tight around the ball
dont know about many of you but the paint I buy has a seem and that is a be-otch to sit there and try and match

[Pig-Demon]

the paint we use is probably about a .686 bore. he uses a .690 or .693. i've checked these and they fall thru. u must have always put it in on the seam then.

[EMSTER]

try JT Maxim, they are a little harder and a little smaller than marbs., but they are perfecrly round with no seems. they fit consistantly well in the barrel. thats all i use any more.:crazy:

[Pig-Demon]

this is with feild paint.