LocTITE

[Bigfloppy]

I recently bought a anx2 regulator, to put it on my new f/x sleeper cocker. To screw it into the asa, i gad to remove the micro gauge. The micro gauge for some reason was covered in locktite. Now that i have screwed the reg in the asa, i need to but the gauge on. 1 problem how do i get the locktite of the micro gauge, it is caked on the threads to the point where i can't see them anymore. I don't wanna take the easy way out nd just locktite the gauge back in, since every time i take the reg off i am goin to need to the the gauge off, i plan to use plumbers tape. Well anyway how do i get this locktite out of the threading so i can go play????

[UTLadiesMan]

Well, you could try a hair dryer and a box of toothpicks or a knife, but your best bet if it's really bad would to go buy some loc tite desolvent. They sell it next to the loc tite, and it's a little expensive, but it should break it up into a mushy goo.