Broken impulse PLEASE HELP

[impulseowner26]

2k impulse
ECS board
ok so heres what happens, im just triggering my gun at home, and all of the sudden it stops making the clicking noise, but the light still flashes, i leave it off for a little, turn it on, makes the noise, then it doesnt, i come home today, turn it on, bam the noise works, but after just a little bit, stops again.
someone told me i have a broken solenoid, or part of my board is fried, what do i do, please help...

[p8ntc4]

probably wats happening is the micro switch is getting stuck on the set screw which is located on top of the trigger and u probably have the set screw out to far so when u squise the trigger it pulls the micorswitch enough to send a signal for the light but not enough to actually trigger the switch. so take of the tray and check out the switch under the board. good luck

[Team Chokepoint]

probably wats happening is the micro switch is getting stuck on the set screw which is located on top of the trigger and u probably have the set screw out to far so when u squise the trigger it pulls the micorswitch enough to send a signal for the light but not enough to actually trigger the switch. so take of the tray and check out the switch under the board. good luck

Um no. If the light goes off, it will send a signal to the solenoid.


Check your batteries ftw :tup:

[droptimepayton]

mine was doing that a few weeks ago take it part and put it back to gether and it should work or it is low battery

[TwistedKazuo]

yeah it is your battery if your battery is low that happened to mine and my friends gun all you need to do is charge or buy a new battery

[ikey]

yeah change the battery. if that doesnt work, make shure your solinoid is plugged in to your board completely. if that doesnt work, try readjusting your trigger, cause it might be possible what p8ntc4 said. try giving your trigger a little more post travel.