LP Mod.

[DeAd-EyE]

To do the LP mod, all you have to do is put the timmy spring into the vigi and take all the parts out of the top regulator housing (except for piston which u put in backwards after right?)

what psi setting should i have the gun set to when running the LP mod. Is it ok to do this if i have a preset tank?

Thanks for ur helpl.
Peace.

[Mr. Deadman]

Remeber to remove the brass pin valve (with a 3/8" nut driver) and spring from the reg housing too. I think the setting on the LP reg stays the same, and since you're using the Vigi as an in-line, a preset tank is fine.

[Scott Misfits]

You have the process for the LP mod right, between you and Mr. Deadman.

As for the LP pressure, try it at 85. Adjust it up or down from there. Set your gun up to shoot 280fps. Play with the LP reg and make you'r velocity rise. As soon as it starts to go down again, turn it back a little bit and leave it. Adjust velocity through your inline reg from then on.

[bluepeter7]

i have some bob long intimidator delrin bolts for sale.30 bucks plus 3 dollars for shipping.. these are the real deal. look at www.888paintball.com they sell them for $44.88. i also have the big low pressure volumizer it's 30 bucks as well. i have the intimidator replacement grips in clear or black with the textured feel to them also. 30 bucks for those. 3 dollars for shipping on anything. if you are interested email me at porterpaintball@hotmail.com or if you need anything else...just ask if i have it