Dwell on Nitro

[Shifty Capone]

how do you and what do i set my dwell thingy if i run the imp on nitro?

[-RuShPB227-]

just about the same as if you were using c02......:tup:

[Killer Kat]

Originally posted by Shifty Capone
how do you and what do i set my dwell thingy if i run the imp on nitro?
My "thingy"(?) is set based entirely on what my chrono tells me to adjust it too. That's why ideally each of you should have a chrono available to you for not only adjusting your Imps to maximum performance, But! The most important reason SAFETY! Nothing ends a fun day of paintballing quicker than someone getting hurt seriously with an mask breaking/eye injury from a hot marker!

[MuckRaker]

Ok, as a future Impulse owner ... what is dwell, and what does it do?

[-RuShPB227-]

the dwell is the amount of time the valve stays open to let air in! :)

[-RuShPB227-]

are you looking into getting an impy muck?

[ds613]

To set the dwell, set the pressure to 170-180 psi, and use the dwell pot (the little adjuster thingy) to adjust the velocity.

[wolverine]

Originally posted by MuckRaker
Ok, as a future Impulse owner ... what is dwell, and what does it do?

Check out the FAQ. It has the answer to this and the next couple question that you will have but do not know you will have yet. :D

[MuckRaker]

Thank you All Might Wolverine ... Psychic Impulse Mod!:D

[2k1AngelShooter]

Speaking of this, I really hate how flimsy the dwell adjustment pots are. I mean I've seen a couple where they've been broken off because your trying to adjust a little pot with a screwdriver while holding a moderately weighted gun and shot it over the chrono? Advice for SP, make something that keeps you from bending the dwell pot over with your screwdriver and it will save on bad boards ok?