newbie impulse ?'s

[Mambaman]

ok, i'm not a newbie to paintball, but i know very little about electros. does this gun have an electronic type grip, and an adjustable (automatic) rate of fire?anything else i should know about these?is the stock barrel any good, and does it come with a reg?thanks

[johnnyrotten]

No it doesn't come with an electronic grip, but you can buy one aftermarket very soon, but its really not worth it. Well I shouldnt say that, What I meant was you dont need it to have a GREAT marker. If you have a Vision on the Imp, you can get 22bps, The Impulse is a very good deal, and www.e-paintballoutlet.com is the best place to buy them, you get the best price and a lifetime warranty, I saw just yesterday, some guy ran his upper adjustment screw for the Blade trigger right into the activator switch, not only was it was replaced for free, but they did a tune-up on it while it was there. Yes they also come with one of the best regs on the market, actually if Im not mistaken, its the only self-adjusting reg there is. We are trying to see how much traffic is coming in from the boards, so just tell them I sent ya.

[Impy4335]

the gun is electro, not just the grip, it has no sear. See the animation on the faq for the internal workings, I cant describe them well. It comes with the wonderful Maxflo reg. The non vision one is adjustable rate of fire, up to 17.5 bps, with vision it is 19.5. It is semi only, noo other modes, except with the genisis board. The stock barrel is ok, but some are better. I like my J&J 2 piece. Hope you like what you see here, and maybe get an Imp. Dont worry about asking stupid questions, we all do sometimes, theyre not stupid though. Please read the ENTIRE faq before asking anymore questions

[johnnyrotten]

From what I was told by SP themselves with the Vision, it CAN be set to 22bps, this is on newer Imps with the VFF and Delrin bolt. Dont ask me why, just relaying info

[Impy4335]

cool, I think it was Wol;vie that told me that, just relaying ifo as well

[-RuShPB227-]

im not a newbie but i have a question. On the new vertical regulators, how to I get to the internals to clean them? The SP site wont work for me because the Normal Reg and the Vert Reg are a little different.

[FOM]

The "front" side of the reg (the side you have to lube) works the same as the horzonal reg. Just unscrew the the adjuster so it comes off the reg, pull out the spring, cradle, pin, and piston. Lube them up and your back in busneiss.

You shouldn't need to do anythng to the "back" side unless something goes wrong. we do not normaly lube the back side.

If you do need to get to the back side, they reg is held into the ASA by 3 set screws. loosne these and slide it out of the ASA adapter and you will see how to disassemble it from there.

Hope this helps

FOM

[-RuShPB227-]

thanks.